Volkswagen ID.4:  Electric drive motor

Removing and installing oil temperature sender -G8-

Removing

• Remove rear centre underbody cladding ⇒ General body repairs, exterior; Rep. gr. 66 ; Underbody cladding; Removing and installing rear centre underbody cladding .
• Drain gear oil ⇒ Rep. gr. 34 ; Gear oil; Draining and filling gear oil .
• Unscrew bolts -1-, and remove cover plate -2-.

• Disconnect electrical connector -arrow-.
• Unscrew bolt -2-.
• Pull out oil temperature sender - G8- -1-.

Installing

Install in reverse order of removal, observing the following:

• Fill gearbox oil ⇒ Rep. gr. 34 ; Gearbox oil; Draining and filling gearbox oil .

Tightening torques

• ⇒ Rep. gr. 10 ; Assembly overview - rear motor

Electric drive motorMotor control unit